"Optimus Prime Figure" (オプティマスプライム・フィギア) is a redeco of 2001 Robots in Disguise Spychanger Scourge, painted to resemble Movie Optimus Prime. Of note is the tampographed detailing on his chest resembling Movie Prime's distinctive chest design. Like most Spychangers, he features high speed axles and can roll very well across smooth surfaces, but lacks the weight to propel him quickly.
Leaving his home universe, the Optimus Prime of Primax 895.0 Gamma was gathered in Axiom Nexus by its Optimus Prime, along with a roster of other Optimus Primes and their kin in a group known as the Convoy, in which he was redubbed "Hero Prime". Optimus Prime bio in Club magazine #49 A multiversal cataclysm in a universe seeded with Rarified Energon and an invasion by natives from the negative polarity universe had called them into action. Since Matrix bearers were usually never allowed into Axiom Nexus, this was a grave threat indeed! Invasion Prologue
The more interesting "Sky Master Mode", revealed in the "Cybertron Satellite" segment of "Phantom Transformation! Mind-Diving", has him using O.P. as a blaster, two B.2s as leg-thrusters, and two sets of C.L./Jida(!) combinations as back-mounted jet packs. The AMW versions of C.L. and Jida, while not as color-coordinated, are a far more economical option than buying two of each Cliffjumper. Good luck with the second B.2. This mode was created as a "counter" to the aerial combatant Starscream, along with the Energon Sniper Combo Weapon (despite it being a Decepticon-Micron-formed weapon). Apparently, the "Arms Up Mission" game isn't picky about factions.
The series begins when Optimus and his crew, after picking up a disillusioned ninja named Prowl, are sent to clear rubble from a space bridge passage. There, the Autobots stumbled upon the Allspark and are immediately attacked by Megatron's battle cruiser, the Nemesis. Through treachery by Megatron's second-in-command, Starscream, Megatron was fragged and the Autobots crashed on Earth in the early 21st century. After being in stasis under Lake Erie for 50 years, the Autobots awaken in Detroit of the near future, where they immediately discovered humans in need and became heroes of the city after stopping a Sumdac Industries experiment gone wrong. During the battle for the possession of the Allspark, Optimus goes offline after defeating Starscream, only to be revived by Sari Sumdac and her Allspark-infused key.
Rodimus appeared in the text-based fiction Dungeons & Dinobots as one of the Autobots who attacked the Arch-Ayr fuel dump. Sent to capture rogue Dinobots for the Autobots, he was part of the group that captured Swoop. Together with Blurr, he then tracked Grimlock, but ran into competition with the Decepticon allies Sideswipe and Cliffjumper. After Grimlock bit off his left hand Ratchet replaced it with a circular saw (a reference to one of the original Rodimus' melee weapons in The Transformers: The Movie).
Though the figure does a much better job of conveying the on-screen character model than the ROTF Leader Class mold did, there are still a few inaccuracies—most notably the forearm and shoulder pad designs and the head/torso proportions. The final product also lacks certain paint details visible in stock and packaging imagery, such as the blue rings on his feet and the gold on his pelvis. It should be noted that this mold does not combine with Jetfire.
Towering at only barely over two inches, this was actually not just the smallest movie-verse Optimus but even the smallest transformable figure of Optimus Prime for a while - ironically enough, being even slightly tinier than the Smallest Transforming Transformers Optimus Prime - that is, until he was later "out-tinied" by two other cute super deformed versions.
Armor Knight Optimus Prime is a retool of Age of Extinction: Generations Leader Class Optimus Prime. It features a new head sculpt with a rotatable faceplate (one side with the mask, the other without, the whole part rotates), along with other remolded body parts (such as his skirt, feet, and chest), giving it a more screen accurate appearance. He includes more movie-accurate weapons, featuring a new sword and shield, albeit in not-so-accurate colors (the sword's transparent orange blade was also a nod to the sword's "heat up" mode in the concept art.). He is covered in metallic paint, along with additional chrome details on his rims and bumper.
The instructions neglect to mention that the entire roof of the cab is on a concealed hinge which greatly eases the difficulty of Prime's transformation. For whatever reason, the instructions treat the toy as if the hinge does not exist, going so far as to show Prime's head magically clipping through his chest to transform. The instructions also neglect to mention that his heel/bumper pieces must be slid out until they click, making the figure just that bit more stable, and that the rotating truck door panels on his upper arms can be pulled further out (but not off) from their sockets, allowing more space for the panels to swing around his hood-arms during transformation.
LEGO is not ignoring the lower priced market, however. As we can see from the chart below, the average price of a set of LEGO has been relatively stable since the 80s2. Even with the average piece count of sets increasing over time, the average price has remained stable. This shows that for all the larger expensive sets being released, they are also releasing plenty of average priced sets that balance out the average. Not only has the size of sets increased but so has the number of sets released per year (prices are in US dollars).
Having been caught unaware by a surprise attack launched by the Decepticons, Optimus led his troops in a losing battle against their mortal enemies. Though Optimus managed to dispatch a few Decepticons, namely Thrust, whom he punched through the chest, he soon found himself crippled and surrounded by enemy forces. Praying to Primus as the Decepticons readied their weapons, Optimus heard Grimlock calling out to his fellow Dinobots to combine, prompting the Autobot leader to yell out a plead to Grimlock to stop. It was too late, however, and The Beast began rampaging, killing Autobots and Decepticons alike. Taking advantage of the situation nonetheless, Optimus tackled Megatron and began beating on the Decepticon leader. The tide of the battle now shifted, Optimus attempted to reach Grimlock’s consciousness within The Beast so that its mindless carnage could come to a halt. It didn't work. The Beast Within
This military-colors redeco of the Auto Roller Dirtbag was planned for late Generation 2 and widely solicited alongside fellow redeco Sargent Hound, but never saw release. Transforming into an "earth mover" dump truck, he has an auto-transforming gimmick activated by rolling his rear wheels; roll forward to go to robot mode, and back to dump truck. A switch on his back end separates the gears of the gimmick, allowing him to roll freely in either mode. In vehicle mode, his missiles can peg onto the front end of the dump-bed for storage. In robot mode, he has a twin spring-loaded missile launcher in his right arm, and a clamping "stun gun" claw on the left.
In time-honored tradition, Prime's instructions depict the toy with an alternate "pretooled" head – in this case, a version with the faceplate deployed, used on the Platinum Edition and "Rusty" releases of the figure (see below). Additionally, his packaging stock photography depicts him with extra white/silver paint details, especially on his chest and wheel rims, as well as having gray upper arms with red details, among other differences.
It uses the 1985 post-rub mold, no metal plates, and the trailer's launcher fires short(this can be modded with some disassembly, Toy Polloi has a video showing how). The wheels roll a bit iffy, this is a common documented issue. Personally I believe there is a slight molding error in the robot, the legs do not seem to fold down quite as far as an official cab's legs do, causing a very slight lean backwards.
Generation 1 Optimus Prime has appeared in numerous video games since the introduction of the Transformers series. He makes a cameo in the 1999 Beast Wars Transmetals video game for Nintendo 64, where he is killed by Megatron at the end of the campaign, showing what would have happened in the Beast Wars series with a Predacon victory. Prime is also one of the playable characters in the 2003 Japan-only Transformers game for the PlayStation 2 and the 2010 Transformers: War for Cybertron. Optimus Prime is also playable in the Hasbro Net Jet Transformers fighting game Transformers Battle Universe. Three versions of Optimus Prime are playable characters, including the first generation incarnation, his incarnations from the 2007 live-action film, and the incarnation from Transformers Animated. In this game, Optimus Primal is also a playable character. He is a regular character in the Nintendo GameCube and PlayStation 2 2003 fighting game DreamMix TV World Fighters. He appeared as a boss in a simple Flash-based video game on the Hasbro web site.
Forming a roughly 11-inch figure when fully assembled, Diablock Convoy is highly articulated, using 12 ball-jointed block pieces, giving him a range of motion similar to Masterpiece Prime, with the exception of the head, which can only move up and down, not side-to side. Speaking of the head, it is by far the most stylised aspect of the figure, with no real attempt to approximate Prime's face or mouthplate inside a simplified helmet, mainly featuring only a reversed block that gives the odd impression of a cycloptic eye. It is possibly intended to actually represent his forehead grill, as a yellow block inside his head construction remains barely-visible through a slit in his face, possibly intended to represent the classic toy's yellow eyes.
In the two-part episode "Megatron Rising", Optimus loses his composure over the recent numerous Decepticon attacks coupled with the fact that Prowl had secretly placed the Dinobots on an island off the coast of Detroit instead of destroying them. He has Ratchet confiscate the Allspark key from Sari, which he loses when he is ambushed by Blitzwing. Optimus also fails to stop a newly resurrected Megatron from acquiring the Allspark. He defeats Megatron by overloading the Allspark in his chest with Sari's key. In the process, the Allspark shatters into countless pieces, scattering all across Detroit.
A giant-sized transforming Optimus Prime figure is set to be released for the third film. The set comes with a Leader Class-sized Optimus Prime figure and a trailer that transforms into his Omega Combat Armor - both of which combine to form Prime's Ultimate mode. This set will be released on August 1st, 2011, a month after the film's premiere.
Released alongside a Sega Mega Drive version of Megatron and outside of any other toyline, "Optimus Prime featuring Original PlayStation" transforms from robot to a scaled-down non-functional Sony PlayStation video game console. He features an opening disc compartment and comes with two accessories, a memory card and a controller that splits in two and attaches to his lower arms to act as blasters.
Optimus Prime returns in Transformers: Revenge of the Fallen. He leads the Autobots as part of NEST in hunting down the remaining Decepticons on Earth. He later engages in a battle with Starscream, Grindor, and a resurrected Megatron. Although Optimus manages to injure Starscream and kill Grindor, he is eventually impaled and killed by Megatron. However, Optimus is resurrected during the battle in Egypt by Sam using the Matrix of Leadership. He is then fused with the dead body of Jetfire, giving him an extremely powerful upgraded mode. After severely maiming Megatron, he kills The Fallen, forcing Megatron and Starscream to retreat. At the end of the film, Optimus thanks Sam for reviving him and again transmits a message to space, hoping to find more Autobots.
Available with Grimlock, this Optimus Prime is a redeco (or possibly a repaint) of the figure above, featuring extra paint applications on the chest and thighs, and he features a different flame pattern on his side doors. His Autobot insignia is now tampographed on his right arm. The cyberglyphs on his front hood is confusingly translated as "PRIME". The 2-pack also comes with a card, which the glyphs being decoded as "DINOBOTS". Optimus Prime and Grimlock also saw release as a Toys"R"Us Japan exclusive, making this Optimus Prime redeco/slight retool to be first sold at Japanese markets.
Thanks to fellow Seibertron user, Sabrblade, we have discovered some new in-hand pictures of the forthcoming Transformers Studio Series #38 Voyager Class Transformers Bumblebee Optimus Prime figure! These come couresty of YouTuber TonTon Reviews, presumably as a preview of his next review. For comparison, they have put this new entry into the Studio Series with MP-10 and Takara Tomy's Movie Advanced series "Classics Optimus Prime" (Evasion Mode Optimus Prime). This gives us a good - Read More
In robot mode, like Combat Hero Prime, the bottom of the truck became his familiar windowed chest based upon the original Optimus Prime toy. His main gimmick was light up LED headlights, and a lightpipe in the bottom of his right fist, illuminated by an LED in his right forearm, that would illuminate his clear sword or his double-barreled rifle if they were used in that hand. All three LEDs were activated simultaneously by pressing the sunroof-like depression on the roof of the truck.